4 axis CNC TB6560 stepper motor controller driver board with fan & cable
CNC stepper motor driver board 96560A V1 adopts the new chip TB6560AHQ of TOSHIBA, the max ouput current can reach to 3.5A , this driver board can drive the 2-phase or 4-phase stepper motor whose current is less than 3A.
The advantages of the TB6560AHQ chip: (1)The vibration of the motor is small and low noise: because of the 2/8/16 resolution can satisfy the different speed. (2)flush type low heat: The area of the chip can support itself to cool when the current is low (3)supports a lot of stepper motors ( 4 ) the advantages in the high-speed running condition
1-4-wire 0-3.5A (normally 3A , the 3.5A is the peak current)can be regulated rate current output, bipolar stepper motor driver
2-Standard parallel port , supports Mach 2, KCAM 4 etc.
3- Optical isolated (IO) and DCDC power isolated to protect the PC parallel port and other equipments
4-Limit and emergency stop port ( standard DB9 port)
5-4 working modes: mixed mode , fast mode, slow mode, standard mode
6- 4-resolution : 1 1/2 1/4 1/16
7-12-36V single power input uses the switch power chip as the 5V power supply, stable and low heat
8-Adopts RC + 7414 auto semi-flow
9-The relay output can control the main axis
10- 5th axis extension control port
Definition of the Pin
1- The 25 Pin of the parallel control
Function of the Pin
All axis EN( enable)
Connect the extension port DB 9 Pin 8
Connect the extension port DB 9 Pin 7
2-Please connect the switch power supply larger than 12-24V 4A as the wiring diagram , the + and ? of the power are showed on the driver board
3-Limit port definition : LPT10= P10 of the PC parallel port , LPT11=P11 LPT12=P12 LPT13= P13 , LPT XX and the COM port connect the power switch. The power signal can be collected by the MACH 3.
4-The 5th extension control port definition: from the top to buttom GND EN GND CW GND CK, they control the EN, pulse- , pluse+, direction- and direction+ of the 5th axis stepper motor
one 4 axis TB6560 driver board