50W Co2 Laser Power Supply for Co2 Laser Engraving and Cutting Machine
This model requre the length of your laser tube not over 80CM,80CM is OK.
If the length of your laser tube is 1m, please choose this one:
Feature: 1.The power supply adopts zero-current half-bridge soft switching circuit, featuring high efficiency, fast response and easy matching for laser tubes produced by various manufacturers. 2.Its ports can be controlled simply to adapt to high and low level signals; the switch of the laser can be controlled by TTL electrical level. Meanwhile, it has an additional abnormal protection switch to test external water supply, ventilation, etc.
3.The laser power can be adjusted by entering either 0 to 5V analog signals or PWM signals.
4.The power supply has open circuit protection function: under the well grounding circumstances, it can work under open circuit state within short term to avoid laser power supply damages caused by laser tube burst.
5.Ex-factory Aging Test:
Each power supply should go through 12-hour, 60°C high temperature aging test under full load with 500 times power supply switches in 7 seconds. Specification: AC Input Voltage AC220V or AC110V DC Input Voltage DC300V or DC150V AC Input Frequency 47~440Hz Voltage Output 25KV Maximum Current 20mA (depending on the laser tubes of different manufacturers) Efficiency 91% Overcurrent Protection 130% of maximum current Open Circuit Protection Yes (short term) Structure Fan cooling High Electric Level Control Voltage Range ≥3V Low Electric Level Control Voltage Range ≤0.8V Working Temperature -30°C~+65°C Relative Humidity 20~85%RH (no condensation) Voltage Resistance Input—Output AC1500V1minutes ≤10mA Input—Shell AC1500V1 minutes ≤10mA Output—Shell Connection Insulation Resistance ≥50MΩ (DC500V) Earth Leakage Current ≤1mA(AC220V) ≤0.5 mA(AC110V) Vibration Resistance Amplitude: 0.5mm frequency 10~55Hz 3D direction 2 hours MTBF ≥30,000 hours Test Time at Full Load and 60°C 12 hours Power Supply Switch Test within 7 Seconds 500 times