Cnc Router 3 Axis Kit,tb6600 3 Axis 4.5A Driver Stepper Motor Controller Kit For Mach3 + 5 Axis Breakout Board

3 x TB6600 4.5A stepper motor driver 1 x 5 axis breakout board 1 x DB25 parallel cable 1 x USB cable English user manual and mach3 software will send by a CD or Email




This driver uses a new original Toshiba TB6600 chip, stable, locked without any noise, built-wheeling, reverse polarity protection. Radiator shell is made of the same size as 2M542 aluminum casing, the cooling effect is very good! some small radiator shell drivers sold by other sellers, is not at the same level to compare with our driver, welcome every customer to Contrast !


1, full support for MACH3, KCAM4, EMC2, the PC software to support parallel port control;
2, leads to all the parallel port of all 12 data transmission output pin, which can control the five stepper motor driver;
3, with 5-way input interface, you can access the limit switches and emergency stop switch, reset knife;5 input LED indicates the status of the input;
4, all the way with a 12A relay control, normally open, normally closed leads, user-friendly connection;
5, power supply with 5V USB power supply or external power supply to facilitate the access of external power supply;On the external drive enable signal amplification, filtering, enhancement processing;
6, the pulse, the direction of signal shaping, enhanced with a carrying capacity, data transmission speeds reach 10 MBit / S;
7, the output pin with extension interfaces can 2.54mm pin 2.54mmXH-Block;


1.DC power input type:12V~48V(Typical 36V);2.Output current:0.6~4.5A;3.Mircostep: 1,2,4,8,16;4.Protect form : Overheated protection,over-current protection,under voltage protection;5.The maximum pulse rate is 200KHZ;6.Dimensions:118mm*87mm*35mm;7.Net Weight:253g; 8.Working environment:Temperature-15~50 degree, Humidity